Magnadyne PL70 Installation manual - page 14
Remote Starter Checkout Procedures
1. Apply the under-hood caution label on the radiator-housing shroud.
2. Remove all tools and close the hood.
3. Verify the transmission is in park position and apply the parking brake.
4. Remove the ignition keys and connect the 6-pin connector to the control module.
5. While seated in the driver's seat, momentarily depress the BLUE start button.
6. The engine should start and run on remote control.
7. Verify that the parking lights illuminate while running on remote control.
8. Verify that the heater and air conditioning system operates as selected.
9. Depress the brake pedal to turn off the remote starter.
10. Start the vehicle by remote control. Depress the start button again to turn it off.
Warning! Verify the parking brake is fully applied and be prepared to depress the foot brake before performing the
following step.
11. Try starting the vehicle by remote control with the transmission in drive/reverse.
12. The engine should not start. If it cranks, depress the brake pedal & call for help.
13. Return transmission to Park. Depress the brake pedal to insure the system is off.
14. Start the vehicle by remote and gently raise the hood. System should turn off.
15. Start the vehicle by remote and verify the programmed remote run time.
Warning! Make sure that no components will interfere with the gas pedal, brake or steering linkages of the vehicle.
Miscellaneous Feature Programming
To Enter Miscellaneous Feature Programming:
1. Turn on the ignition key.
2. Depress program switch [15] times within 30 seconds after turning on the ignition.
3. The parking lights will flash [15] times. The horn will chirp [15] times.
4. You are now in miscellaneous feature programming mode.
Panic Feature Operations: [Factory Default Setting Allows Panic At All Times]
The module can be programmed to prevent panic operations when the ignition is on. In addition, the panic feature can be
permanently programmed off and no longer respond to the panic button on the transmitter, if desired.
To Prevent Remote Panic Activation When the Ignition is On:
• Depress the LOCK button.
• The parking lights will flash [2] times. The horn will chirp [2] times.
To Prevent Remote Panic Activations at All Times:
• Depress the LOCK button.
• The parking lights will flash [3] times. The horn will chirp [3] times.
To Allow Remote Panic Activation at All Times: [Factory Default Setting]
To allow panic activation regardless if Ignition is On or Off:
• Depress the LOCK button.
• The parking lights will flash [1] time. The horn will chirp [1] time.
Double Unlock Pulses: [Factory Default Setting Is Singe Pulse]
Some vehicles require [2] unlock pulses to unlock the doors by remote control.
To Program the Module for [2] Unlock Output Pulses:
• Depress the UNLOCK button.
• The parking lights will flash [2] times. The horn will chirp [2] times.
To Program the Module Back to [1] Unlock Output Pulse: [Factory Default 1]
• Depress the UNLOCK button.
• The parking lights will flash [1] time. The horn will chirp [1] time.
14