1 english ( o rigina l in st ruct ions) instruction manual warning: for your personal safety, read and understand before using. Save these instructions for future reference. Cordless metal cutter bcs550 007522.
2 english specifications model bcs550 blade diameter 136 mm max. Cutting depth 51 mm no load speed (min -1 ) 3,600 overall length 348 mm net weight 2.6 kg rated voltage d.C. 18v • due to our continuing programme of research and development, the specifications herein are subject to change without not...
3 save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Work area safety 1. Keep work area clean and well lit. Cluttered or dark areas invite accidents. 2. Do not ope...
4 22. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 23. Use the power tool, accessories and tool bits etc. In accordance with these instructions, taking into account the working conditions and the wor...
5 backward while the blade is in motion or kickback may occur. Investigate and take corrective actions to eliminate the cause of blade binding. • when restarting a tool in the workpiece, center the blade in the kerf and check that blade teeth are not engaged into the material. If blade is binding, i...
6 4. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight. 5. Do not short the battery cartridge: (1) do not touch the terminals with any conductive material. (2) avoid storing battery cartridge in a contain...
7 for cleaner, safer cuts, set cut depth so that no more than one blade tooth projects below workpiece. Using proper cut depth helps to reduce potential for dangerous kickbacks which can cause personal injury. Sighting 2 1 3 007525 when cutting, align the a position on the front of the base with you...
8 to remove the blade, press the shaft lock so that the blade cannot revolve and use the wrench to loosen the hex bolt counterclockwise. Then remove the hex bolt, outer flange and blade. To install the blade, follow the removal procedure in reverse. Be sure to tighten the hex bolt clockwise securely...
9 • do not cut hardened steel, stainless steel, wood, plastics, concrete, tile, etc. Cut only mild steel and aluminum. • do not touch the blade, workpiece or cutting chips with your bare hand immediately after cutting, they may be extremely hot and could burn your skin. • always use the blades appro...
10
11.
12 makita corporation anjo, aichi, japan 884688b228.
