NBN 9320 User Manual - Teds
Interface 9320 TEDS Ready Indicator Manual Issue 2.4
11
tedS
ENABLING TEDS DISABLES CALIBRATE MENU
Press
to skip this parameter and exit menu
Press
to enable or disable TEDS.
If you have chosen to enter the TEDS calibration,
EnAbLEd?
appears.
If you have chosen to enter the TEDS you will be prompted whether you want to select
EnAbLEd?
if you do not press
,
otherwise press
. If you have selected enabled, two
flashing indicators will appear.
For more detailed TEDS calibration information, please refer to the TEDS section of the
manual.
Operation Features
Normal Display Operation
The 9320 has a full 7 digit display, which can be scaled using the calibration menu to suit the application it is to be
used in. The display can display the instantaneous, peak or valley values. It is also possible to hold the display value
(this only operates when not in peak or valley mode).
The display update rate, decimal point position and resolution can be set to suit.
The 9320 has two independent ranges. All values set in one range are totally independent from the other.
Switching the 9320 On/Off
The 9320 is switched ON or OFF by pressing and holding down the button for 3 seconds.
It is also possible to set an Auto-off value in the configuration menu, so that the 9320 automatically switches itself
off after a preset time, if there is no keyboard activity.
RANGE Button
The range feature allows for the setting of two totally independent setup ranges to be selected, if required. To
switch between ranges simply press the range button. If TEDS has been enabled then only 1 range is permissible.
When you enter either the calibration menu or configuration menu, the parameters you will be setting are those for
the range you have selected. An annunciator is lit to identify which range has been selected.
The 9320 is supplied with engineering unit legends; these can be slid into a window, located on the inside of the
front panel. These labels then help to further identify the units being displayed for each range. Please refer to the
photo below:
Legend labels are
inserted both sides