NCR RealPOS User Manual - Gs1 Databar Expanded Stacked
Chapter 6: Special Programming
6-7
GS1 DataBar Expanded Stacked
GS1 DataBar Expanded Stacked is similar too GS1 DataBar-14 Stacked except it uses the GS1
DataBar Expanded format for creating the symbol.
19257
0192 1234 5698 7457 3202 0000 9939 0200 296
Send GS1 DataBar14 as EAN13 Tag Data
When enabled, the scanner sends the last 13 digits of the GS1 DataBar14 data to the host
terminal. The Default tag does not change this parameter.
Enable—Program Mode, Hex 6, Hex 0, Hex 5, and Save and Reset
Disable—Program Mode, Hex 6, Hex 0, Hex 4, and Save and Reset
Terminal Coupon Interface Parameters
Certain parameters must be set to permit the unit to transmit coupon data to the host terminal.
These are in addition to the general parameters that are required for other scanner functions.
Note:
Selection of optional add-on bar codes may require additional programming.
To set the Coupon Interface Parameters, you perform a series of steps in a designated order.
The following step begins the series.
Terminal Coupon Select 1 Parameters
1. Scan the Programming Mode tag.
2. Scan the Hex 3 and Hex 8 tags to select this parameter.
3. Scan a Hex 0 through Hex F tag to set a Coupon Select 1 parameter.
22811
Disable
Coupon Select 1 Parameter
Enable
Hex 0
Coupon with P5 optional
Hex 1
Hex 2
Coupon with 128 add-on optional
Hex 3
Hex 4
Coupon with 128 add-on mandatory
Hex 5
Hex 6
Markdown with 128 add-on optional
Hex 7
Hex 8
Program 1 with 128 add-on optional
Hex 9
Hex A
Program 1 with 128 add-on mandatory
Hex B
Hex C
Program 2 with 128 add-on optional
Hex D
Hex E
Program 2 with 128 add-on mandatory
Hex F
4. Scan the Save and Reset tag to save the program (required).