NCR RealPOS User Manual - Label Identifiers
Chapter 5: Programming 5-43
Label Identifiers
Identifier Type
Default Prefix
25514
A
Common Byte 1
B
Common Byte 2
C
Bar Code Type
D
Common Byte
Unique Identifier
0 - 7
5
Default
Hex Character
(ASCII Code Chart)
0 - F
Hex Character
(ASCII Code Chart)
0 - 7
Default
Hex Character
(ASCII Code Chart)
0 - F
Hex Character
(ASCII Code Chart)
None
Unique Prefix
0
2
3
UPC-A
0
UPC-E
2
EAN-8
3
EAN-13
4
Code 39
5
Code 128
6
Interleaved
2 of 5
7
None
0
Common
Byte 1
1
Common
Byte 2
2
Both
Common
Bytes
3
1
0 - 7
Hex Character
(ASCII Code Chart)
0 - F
Hex Character
(ASCII Code Chart)
Common Byte and
Unique Identifier Defaults vary
according to Bar Code Type
D
4 2
GS1
DataBar 14
8
9
GS1 DataBar
Expanded
AIM
Label ID
4
UPC-D
1
1 6
Unique Identifier
Common
Byte
Your Program
Identifier
Type
A
Common
Byte 1
B
Common
Byte 2
C
Bar Code
Type
D
Label
Identifiers
9
GS1 DataBar
Expanded
Pharmacode
A
B
Codabar
No Unique
ID
5
The Label Identifiers programming mode selects the parameters for adding label identifiers to
communication messages. These identifiers apply to the NCR USB and RS-232
communication protocols. Label identifiers for the other modes of communication are
determined by the firmware and are not programmable.
Identifier Type
The Identifier Type parameter defines the type and placement of label identifiers. Default
identifiers that prefix the message data, unique prefix identifiers, or no identifiers can be
selected.
Select the Identifier Type parameter by scanning the appropriate tag (Hex 0, Hex 2, or Hex 3).
If default identifiers are selected, do not enter any other parameter in this programming mode.