NCR RealPOS User Manual - Bar Codes–1
Chapter 5: Programming 5-25
Bar Codes–1
UPC/EAN
Your Program
0
Disable
24037
A
UPC/EAN
A
1
Enable
C Extend UPC-A
To EAN-13
0
Disable
1
Enable
D Extend UPC-E
To UPC-A
0
Disable
1
Enable
E Periodical
Codes
0
Disable
1
Enable
Periodical
Code
Extension
0
2-Digit
Only
1
5-Digit
Only
2
2-Digit &
5-Digit
Send Data
0
Data AS
Decoded
Bar Codes - 1
1
3
Unused
B
Extend
UPC-A
C
Extend
UPC-E
D
Periodical
Codes
E
Periodical
Code
Extension
Send
Data
B Unused
0
Disable
Set 2 Tag
Label
F
F Set 2 Tag
Label
Enable
A
Disable
2
The Bar Codes–1 programming mode contains programming parameters for UPC/EAN bar
codes. Refer to the “Parameter Defaults” earlier in this chapter for the factory defined default
value of each programming parameter.
UPC/EAN
The UPC/EAN parameter controls reading UPC/EAN bar codes. Disable reading UPC/EAN
bar codes by scanning the Hex 0 tag and enable reading by scanning the Hex 1 tag.