NCR RealPOS User Manual - Bar Codes–4
5-34 Chapter 5: Programming
Scans Required
This parameter sets the number of scans required to read an Interleaved 2 of 5 bar code.
Increasing the number of scans can improve reading nominal bar codes. There are four
settings: 1 scan, 2 scans, 3 scans, and 4 scans. The default is 2 scans. Set this parameter by
scanning the appropriate Hex tag (Hex 1 to Hex 4).
Overlap Characters
This parameter sets the minimum number of characters which each segment must contain
when tag stitching is done. There are four settings: 1 overlap character (Hex 1) (default), 2
overlap characters (Hex 2), 3 overlap characters (Hex 3), and 4 overlap characters
(Hex 4). Set this parameter by scanning the appropriate Hex tag (Hex 1 to Hex 4).
Minimum Segment Size
This parameter sets the minimum number of characters which each segment must contain
when tag stitching is done. Set this parameter by scanning the appropriate Hex tag (Hex 2 to
Hex 9). The default is
Hex 3.
Bar Codes–4
22766
Code 128
A
0
Disable
1
Enable
Minimum Data
Characters
Allowed
B
1
2
3
4
5
EAN/UCC 128
C
0
Disable
1
Enable
Your Program
Bar Codes - 4
1
7
A
Code 128
B
Minimum
Data
Characters
Allowed
C
UCC 128
Partial
Decoding
F
0
Disable
1
Enable
NOTE: Direct Entry Only.
Bar Codes - 4
1
7
F
Partial
Decoding