NCR RealPOS User Manual - Bar Codes–6
5-40 Chapter 5: Programming
Bar Codes–6
25515
Codabar
Decoding
A
0
Disable
1
Enable
Codabar
Length
B
0
1-36
1-36
Codabar
Check Digit
C
0
Disable
1
Enable
Your Program
Bar Codes - 6
1
A
A
Codabar
Decoding
B
Codabar
Legth
C
Codabar
Check Digit
Codabar
Check Digit
Transmission
D
0
Disable
1
Enable
D
Codabar
Check Digit
Transmission
Codabar Length Range Check
Maximum Length
(Default =
36
)
Minimum Length
(Default =
4
)
1
1-36
1-36
Codabar Specific Length Check
Maximum Length
(Default =
36
)
Minimum Length
(Default =
4
)
The Bar Codes 6 programming mode contains programming parameters for Codabar bar
codes. Refer to the “Parameter Defaults” section earlier in this chapter for the factory defined
default value of each programming parameter.
Codabar Check Digit
The Codabar Check Digit parameter permits control of Codabar check digit requirement. Scan
the appropriate Hex tag (Hex 1 to Hex 0) to enable or disable the check digit. The default is
Hex 0—Disable Codabar check digit.
Codabar Check Digit Transmission
The Codabar Check Digit Transmission parameter selects whether to send the check digit to
the host terminal. Scan the Hex 0 tag to disable this option, or the Hex 1 tag to enable this
option.