Nds Surgical Imaging Dome Ex User Manual - Installing The Display
Installing the Display | 5
Installing the Display
Before you install the display controller, remove any graphics card and its driver from
your system. Also disable any onboard graphics capability on the motherboard.
Install your Dome display with one of the qualified graphics cards shown in the
following table. See the I/O bracket of the graphics card on “Qualified Graphics Cards”
NVS
QUADRO
DISPLAY
295
*
* DisplayPort-to-DVI adapter required.
FX 380
600
†
† DisplayPort-to-DVI adapter required for second Dome Ex display, except Dome E3cHB DisplayPort.
2000
2000D
4000
Dome E2
9
9
9
9
9
9
Dome E2cHB
9
9
9
9
9
9
Dome E3
9
9
9
9
9
Dome E3cHB
9
9
Dome E3cHB
DisplayPort
9
9
9
9
9
Dome E4c
‡
‡ Refer to
Dome E4c Display User’s Guide
for instructions.
9
9
Dome E5
9
9
9
9
9
Warning
In locations where 240V outlets are used, connect the Dome Ex display only to a
center-tapped, 240V, single-phase supply (for Canada and the United States only).
If you leave the computer turned on, you could get an electric shock and cause damage to
the system components.
Remove the display controller slowly from its package and static-shielding bag to prevent
an electrostatic discharge.
Static electricity can damage the controller. When touching the board or parts of the
motherboard, take these precautions:
• Wear an antistatic wrist strap.
• Discharge your body’s static electricity repeatedly by touching the power supply or the
metal surface of the computer chassis.