Nds Surgical Imaging Dome Ex User Manual - page 9
Installing the Display | 7
NOTE: For installation of the Quadro 4000 board only. If your
computer lacks a built-in 6-pin connector from the power supply, you
need to use the adapter cable supplied with the display controller to
complete the installation of the board.
Connecting the Video and Power Cables
Turn your computer off. Leave the power cord plugged into
the grounded outlet. Use the Dome Ex display with the power
adapter and video cable shipped.
IMPORTANT! Note the following:
• Display configurations using the NVS295 board may require a
DisplayPort-to-DVI adapter.
• Display configurations using the Quadro 600, 2000, or 4000 board,
except
for the
Dome E3cHB DisplayPort
unit
, require a DisplayPort-
to-DVI
adapter for the second display.
• For the Dome E3cHB DisplayPort unit only. Install either the DVI or
the DisplayPort video cable, not both.
To connect the cables
1 Plug one end of the video cable into the video port on the interface
plate. Secure the connection.
2 Plug the power cord into the power input port on the
interface plate.
3 Plug the other end of the video cable into the video port on the
installed display controller. (Use the bottom port of a single display
installation or for the first display of a multiple display setup.)
Secure the connection.
4 Plug the other end of the power cord into the power supply.
5 Repeat steps 1 to 4 to connect another display to the controller.
6 Plug the power supply cord(s) into a grounded AC outlet.
7 If you are using a BridgePower adapter, turn on the adapter power
switch before you turn on the computer.