NEC EXPRESS5800 N8403-019 System Configuration Manual - Server Configuration
SYSTEM CONFIGURATION GUIDE
–
NEC Express5800/AT101b
NEC Corporation
Revision 1.1
– January 16, 2013
6
Server Configuration
1 Storage Blade
Product Name / Description
Part Number
NEC Express5800/AT101b
LTO5 Drive, Two mezzanine PCI Slots, Two 1000BASE
N8404-005F
2 I/O Expansion Card
2.1
Network Interface Controller
Category
Product Name / Description
Part Number
Adapter
Type I
GbE
1000BASE (2ch) Adapter
Intel® 82571EB Gigabit Ethernet Adapter
N8403-021
Dual Port 1000BASE Adapter
Intel® Ethernet Controller I350-AM2
N8403-076F
Adapter
Type II
GbE
1000BASE-T(4ch) Adapter
Intel® 82571EB Gigabit Ethernet Adapter
N8403-022
Quad Port 1000BASE Adapter
Intel® Ethernet Controller I350-AM4
N8403-077F
NOTE:
The NIC cards which can be installed on a tape blade are the NIC cards which are supported on the
server blade attached. For the NIC cards supported, see the system configuration guide for server
blade.
NIC Teaming / Bonding feature
When using NIC teaming, please note the following:
Any of the network teaming must be processed in a single LAN controller.
Teaming feature is not supported on iSCSI interfaces.
To configure NIC bonding on Red Hat Enterprise Linux, see the configuration guide for the server
blade attached.
2.2
External Storage Controller
2.2.1
Fibre Channel Controller
Category
Product Name / Description
Part Number
Adapter
Type I
Fibre Channel Controller(8Gbps/2ch)
Emulex LightPulse LPe1205-N Host Bus Adapter
N8403-034
NOTE:
Link speed of two ports in one cards should be used with the same link speed.