NotifEye Wireless Sensors and Ethernet Gateway Manual - Mounting Sensors
12
Contents Page
Mounting Sensors
Sensors should be placed on a clean, dry, flat surface. Place them at least 3 ft away from each other
and any wireless gateway for clearest transmissions.
Do not place the sensor body inside any refrigerator/freezer cabinet or storage area since this will interfere
with sensor performance.
Sensors can be mounted in a variety of ways including using the screws or loop & lock tape that
comes in your NotifEye kit. To use the loop & lock tape, peel off the sticky back and affix to the back
of the sensor. Peel the other sticky side off and press the adhesive to the desired location. Next,
secure probe inside the cabinet with moisture-resistant tape, cable-ties or other suitable method.
Advanced
Adding, Editing and Setting User Permissions
Adding New Users
To add new users, click on the “My Account” button at the top right hand of the screen. From the
“My Account” page, select Account Users from the left panel
Note
In order to make changes to users, you’ll need to have administration privileges to the account.
4
Fig. A - temperature sensor mounted to the outside of a walk-in refrigerator, showing the probe wire
routed through the door gasket.
Fig. B - temperature sensor mounted to the outside of a walk-in refrigerator, showing the probe wire
routed through a panel meter.
Fig. C - temperature sensor mounted to the outside of a reach-in refrigerator, showing the probe wire
routed through the door gasket.
Fig. A
Fig. B
Fig. C
5
Add New User
Delete
Users
Edit
User