NotifEye Wireless Sensors and Ethernet Gateway Manual - page 7
7
Contents Page
7. Current Sensor Information
Displays the most current information of the selected sensor, including: last check-in, signal strength,
battery power and last sensor reading.
8. Sensor Data Window
Select a tab to change between:
History
- displays a history (in list form) of the sensor’s data.
Notifications - allows you to view, add, edit or delete notifications for the sensor.
Chart
- displays a graphical view of the sensor’s data.
Export
- allows you to archive data by exporting as a .csv file.
Edit
- allows you to change configurations such as sensor name and heartbeat.
Note:
The tab highlighted in
green
is your current selection.
9. Date Range Selector
Allows you to choose the date range for viewable information such as sensor history, notifications
sent, charts and sensor data export.
Configuring Sensors
To set a sensor’s configurations, from the Sensor List, click the “Edit” icon next to the name of
the sensor that you would like to configure. Alternately you can click on the “Edit” tab in the Sensor
Data Window to access this same area. The Temperature Sensor Configuration window allows you
to set the primary configurations for each sensor. Within this window you can change the name of
the sensor, set the heartbeat (how often the sensor checks-in with the software - 120 minutes is
recommended), and change the unit of measurement. When you have finished making changes,
press the “Save” button at the bottom of this section.
Note:
Be sure to click the “Save” button anytime you make a change to any of the sensor parameters. All changes made
to the sensor settings will be downloaded to the sensor on the next sensor heartbeat (check-in). Once a change
has been made and “Saved,” you will not be able to edit that sensor’s configurations again until the sensor has
downloaded the new setting.
Sensor Name
The name of the assigned sensor, e.g., Freezer 1.
Display As
Indicates whether temperature is displayed as °F or °C. Slide the grey bar to change between them.
8. Sensor Data Window
7. Current Sensor Information
9. Date Range Selector