NotifEye Wireless Sensors and Ethernet Gateway Manual - page 5
5
Contents Page
• Press the “Assign Sensor” button. The sensor will now appear in the sensor list.
• Repeat this process to add more sensors to this network.
Note:
Sensors contain initial factory data that should be cleared before collecting new data. To do this, click the
“Clear Data” link.
2. Adding Additional Gateways.
• Choose the “Manage” tab from the main navigation bar.
• From the “Network Settings” pane on the left, select the network you would like to add the
gateway to.
• In the section “Gateway List / Assign Gateway”, enter the Gateway ID and Security Code from
label of the gateway you want to add.
• Press the “Assign Gateway” button. The gateway will now appear in the gateway list.
Editing Gateway Settings
It is recommended you leave these at their default settings. If you need to edit these settings, click on
the “Overview” tab and from the Gateway List pane, and click the “Edit” icon
next to the gateway.
The ethernet gateway uses Dynamic Host Configuration Protocol (DHCP) to automatically acquire a
network address from the Local Area Network (LAN). We recommend that the “Use DHCP” box be left
checked. In the event that it needs to have an address manually assigned to it, you can assign an IP
address as well as a gateway mask and default DNS through the online interface.
Note:
This advanced configuration is NOT required in most instances. In the event that it is required, you will need to
initialize it on a network that can reach the online system with the default DHCP settings allowing your configuration
settings to be downloaded to the device.
Reform Network - assures system is operating on the most optimal RF frequency.
Reset Gateway to Factory Defaults - resets gateway to manufacturer defaults. This will only work if
the gateway is connecting with the system.
3. Creating Additional Networks.
• Choose the “Manage” tab from the main navigation bar.
• From the “Network Settings” pane on the left, click the “Add Network” link and a new network
will appear in the list. To change the default name of this network, (e.g., Network 3355) in the
“Network Details” pane, click the “Edit Network Details” icon
.
• Enter a new name and then click “Save” and the network will appear in the settings list.
There are two checkboxes in this section:
Holding Network - leave unchecked for normal system operation. Check the box if you wish to set up
a gateway, sensors and a network but you do not wish to actively collect data from
live sensors.
Send notifications for this Network - if checked, any set notifications will be sent (see page 9).
• Under “Gateway List / Assign Gateway”, enter the Gateway ID and Security Code from the
gateway you want to add, then press “Assign Gateway”. The gateway will now appear in the
gateway list.