NotifEye Wireless Sensors and Ethernet Gateway Manual - Setting Up The Online System
4
Contents Page
Inserting Batteries
Slide the coin cell battery into the sensor as shown in fig.1. Push the battery all the way to the back
using a paper clip. It will power on within 10-20 seconds. Once you have assigned all your sensors to
a network in the online system, they are ready to be mounted.
Warning:
Your sensors ship with a 10-minute heartbeat. It is recommended that
you set the heartbeat to no faster than two hours to extend battery life (see page
8, “Configuring Sensors”). Under normal operating conditions, a sensor set at a
2-hour heartbeat will last for 3000 transmissions.
When changing a sensor’s heartbeat, the new configuration information will be
sent to the sensor on the next heartbeat.
Note:
If the sensor status indicator (page 6) does not change, reset the sensor by
removing the battery. Wait 60 seconds then re-insert the battery. When inserting the battery, make sure to push the
battery all the way back using a paper clip.
Manual Sensor Reset Process:
If you want to update the sensors immediately, you can reset them manually by doing the following.
a) Using the end of a paper clip, push the batteries out of the sensors through the small hole in the
top of the sensor.
b) Wait 60 seconds.
c) Re-insert the batteries into the sensors.
Important:
Do not mount sensors before entering their IDs and codes
into the online system (see page 5).
Setting Up The Online System
Logging into the System
On the home page, enter your username and password you just
created (page 2, 4.) in the login fields and click the “Login” button.
Adding Sensors, Gateways and Networks
These steps will allow you to add sensors, gateways and networks to your
account. If you have additional gateways you can either set them up as their own individual networks
or add them to your existing network and manage them from one account.
1. Adding Sensors.
• Choose the “Manage” tab from the main navigation bar.
• From Network Settings in the left navigation, select the network to which you would like to add
the sensor.
• In the section “Sensor List / Assign Sensor”, enter the Sensor ID and Security Code from the
label on the bottom of the sensor.
+
_
Battery
Fig. 1
3
Clear Data