Novatac EDC-120P User Manual - 3. Brightness Settings.
3. Brightness Settings.
The light has 21 or 22 brightness levels and 3 signal levels available.
Four of these are preset at the factory. The 4 settings are called
Primary, Secondary, Minimum and Maximum. Any of the 22
brightness levels may be assigned to any of the preset settings.
The 3 signal levels are: Disorienting Strobe, Emergency Strobe, and
SOS, respectively. Any of these 3 signal levels may be assigned in
place of solid light output on any of the 4 pre-sets.
The disorienting strobe can induce seizures in certain individuals so
it should be used with caution.
When setting brightness, the light will blink twice when the highest
brightness level is reached then display Disorienting Strobe,
Emergency Strobe, and SOS signals. Each signal level will be
displayed for 4 seconds before moving to the next level. When the
lowest brightness is reached the light will blink twice at that level.
The brightness ramp is circular in nature. The highest brightness
setting is followed by the Disorienting Strobe, Emergency Strobe,
and then SOS. SOS is followed by the lowest brightness level and
vice versa.
Changing Brightness Settings (from on, 2 Clicks-Press-hold)
The light will always begin the ramping process by increasing
brightness.
From your choice of preset settings:
1.
Increase the brightness level with Click-click-press-hold.
Brightness will increase, blink twice at Maximum then proceed
to the three available signal settings.
2.
Release the button when the desired brightness or signal level
is reached.
3.
Do not turn the light off unless you want to save the setting.
4.
Turn the light off to remember the brightness or signal level for
this preset.
5.
Decrease brightness level with click-click-press-hold until
brightness begins to increase then release the button.
6.
Repeat the click-click-press-hold. Brightness level will
decrease.
7.
Release the button when the desired brightness or signal level
- 4 -