Novatac EDC-120P User Manual - To Enter The Options Menu:
If the button is not pressed for 10 seconds, an unknown command
is entered, or the button is not held until the light turns off, the light
will exit the Options menu unchanged. The error flash sequence of
six rapid flashes will be displayed and the light will return to the last
setting accessed.
To enter the Options Menu:
1. Turn the light on to any brightness level.
2.
Click-Click-Click-Press the button. When the button is released,
the Emergency Strobe identification will flash. This is the first
menu item.
3.
Click once to move to each of the next options. Double-clicking
will reverse the direction.
4. When the desired option is reached,
Press and Hold the button
for 2 seconds until the light turns off. If the option is being
enabled, the light will display an increasing brightness sequence.
If the option is being disabled, the light will display a decreasing
brightness sequence.
5.
Release the button when the light turns off.
6. The Option is set and the light will return to the brightness setting
it was on when the Options Menu was accessed.
If there is insufficient power to remember the setting, the light will
flash rapidly for 2 seconds then turn off. The selected changes will
take effect temporarily but be deleted at the next battery change or
soft reset.
Option 1: Emergency Strobe
(flash)
The Emergency Strobe option flashes the maximum brightness
once a second. It is intended to be used as an emergency beacon.
Setting it once enables it. To stop the Emergency Strobe signal, turn
the light off.
If the Automatic Turn-Off option is enabled, the Emergency Strobe
will turn off after 5 minutes.
The default setting is: Disabled.
The Emergency Strobe may be assigned to any brightness level. See
Changing Brightness Settings.
- 6 -