Oberheim OB 12 Operating Manual - page 109
OB 12
Z-Domain Synthesizer
229
at twice the speed of the signal (for example, the arpeggio tempo or the LFO Rate) with which
it is synchronised. The values available range from 0.1X to 10X.
Pressing the [F2] function key displays the video page relating to the MIDI Real Time messages
transmitted:
These are the parameters which can be adjusted:
•
STATUS: enables (ON) and/or disables (OFF) transmission of the MIDI Real Time messages.
•
SOURCE: specifies the system from which the Start, Stop and Continue instructions are to be
taken. The possible choices are:
-
ARPEGGIO: when the Arpeggio is activated by pressing a keyboard key, the MIDI START
message will be sent. When the key is released (interrupting the Arpeggio), the STOP
message will be sent.
Depending on the setting of the STOP AS parameter, pressing a key again will send the
START/STOP or CONTINUE messages.
-
PHRASE REC: when a Phrase is recalled by pressing a keyboard key, the MIDI START
message will be sent. When the key is released (interrupting the playing of the phrase), the
STOP message will be sent.
Depending on the setting of the STOP AS parameter, pressing a key again will send the
START/STOP or CONTINUE messages.
-
MOTION REC1: when Motion 1 is activated, the START message will be sent. When it is
interrupted, the STOP message will be sent.
Depending on the setting of the STOP AS parameter, reactivating the Motion will send the
START/STOP or CONTINUE messages.
-
MOTION REC2: when Motion 2 is activated, the START message will be sent. When it is
interrupted, the STOP message will be sent.
Depending on the setting of the STOP AS parameter, reactivating the Motion will send the
START/STOP or CONTINUE messages.
-
AUTO MORPH: when the automatic Morphing is activated, the START message will be
sent. When performance of the Morphing is interrupted, the STOP message will be sent.
Depending on the setting of the STOP AS parameter, reactivating the function concerned
will send the START/STOP or CONTINUE messages.
•
STOP AS: defines which MIDI Real Time messages will be transmitted when the section with
which they are associated is activated and/or disabled.
The table below indicates the messages sent depending on the setting of the parameter.
The next video page, displayed by pressing the [F3] function key, allows you to set the parameters
relating to the MIDI Real Time messages received.
S TOP A S: STOP
S TOP A S: CONTINU E
Function start
START
START
Function stop
STOP
PAUSE
Next function start
START
CONTINUE