Oberheim OB 12 Operating Manual - page 69
OB 12
Z-Domain Synthesizer
189
for high pressure values.
-
DELAYED: Curve which delays the emission of data, which are not generated until high
pressures are applied to the key, after which high Aftertouch values are reached easily.
-
INVERTED: Inverted Aftertouch curves have the same properties as reversed Velocity curves.
•
PARAMETER: selects the generation parameter for which the influence of Aftertouch-control
is to be set by means of the INFLUENCE field.
This is the list of the parameters available and the relative panel controls:
•
INFLUENCE: sets the influence of the Aftertouch in controlling the parameter specified in the
PARAMETER field.
You can now use the [F3] key to select the RIBBON folder, thus displaying the video page relating
to the assignments of parameters to the Ribbon Controller.
This device allows you to control both the parameters relating to sound generation by moving a
finger over the surface of the control.
•
FUNCTION1: assigns the first function to the Ribbon Controller.
•
FUNCTION2: assigns the second function to the Ribbon Controller.
•
MIN and MAX referred to FUNCTION1 and 2: set the minimum and maximum values of the
parameters to which they refer.
SELECTIONS
CONTROLLED
PARAMETERS
CONTROLS ON
PANEL
SELECTIONS
CONTROLLED
PARAMTERS
CONTROLS ON
PANEL
AMP-AMOUNT
timbre level
[AMOUNT] of
AMPLIFIER
OSC2-LFO1D
modulation depth of
LFO1 in OSC.2
[LFO1 DEPTH] of
OSC.2
FLT CUTOFF
filter cut-off frequency
[FREQUENCY] of
FILTER
FLT-LFO1 D
modulation depth of
LFO1 in FILTER
[LFO1 DEPTH] of
FILTER
BALANCE 1
balance between
OSC.1 and OSC.2
[BALANCE 1] of
OSC.COMMON
AMP-LFO1 D
modulation depth of
LFO1 in AMPLIFIER
[LFO1 DEPTH] of
AMPLIFIER
BALANCE 2
balance between
OSC.1+OSC.2 and
RING MODULATOR
[BALANCE 2] of
OSC.COMMON
OSC1-FM
frequency modulation
depth of OSC.2 in
OSC.1
[FM] of OSC.2
BALANCE 3
balance between
OSC.1+OSC.2+RING
MODULATOR and
NOISE
[BALANCE 3] of
OSC.COMMON
OSC2-DTUNE
fine tuning of OSC.2
[FINE] of OSC.2
OSC1-PWDTH
modulation depth to the
OSC.1 impulse
[PWM DEPTH] of
OSC.1
LFO1-RATE
LFO1 signal frequency
[RATE] of LFO1
OSC2-PWDTH
modulation depth to the
OSC.2 impulse
[PWM DEPTH] of
OSC.2
LFO2-RATE
LFO2 signal frequency
[RATE] of LFO2
OSC1-LFO1D
modulation depth of
LFO1 in OSC.1
[LFO1 DEPTH] of
OSC.1