Oberheim OB 12 Operating Manual - page 110
OB 12
Z-Domain Synthesizer
230
these are the parameters displayed in the video page:
•
STATUS: enables (ON) or disables (OFF) the reception of MIDI Real Time messages.
•
DESTIN.
(Destination)
: specifies the system to be controlled by the Real Time commands. The
possible choices are:
-
MOTION REC1: the Real Time messages control the starting and interruption of Motion 1.
-
MOTION REC2: the Real Time messages control the starting and interruption of Motion 2
-
AUTO MORPH: the Real Time messages control the starting and interruption of the
automatic Morph.
If the RX CLOCK folder is now selected using function key [F4] it will be possible to display the
video page relating to setting of the MIDI Clock message being received. The video page displayed
is the following:
in which the following parameters can be seen:
•
ARPEGGIO: sets the multiplication factor (from 0.1X to 8X) of the incoming MIDI Clock assigned
to the Arpeggio. If the parameter is set as OFF the Arpeggio Tempo will not be linked to the
MIDI message mentioned.
•
PHRASE REC.: sets the multiplication factor (from 0.1X to 8X) of the incoming MIDI Clock
assigned to the Phrase Recorder. If the parameter is set as OFF the Phrase Recorder Tempo
will not be linked to the MIDI message mentioned.
•
AUTO MORPH: sets the multiplication factor (from 0.1X to 8X) of the incoming MIDI Clock
assigned to the automatic Morph. If the parameter is set as OFF the Auto Morph Tempo will
not be linked to the MIDI message mentioned.
The top right-hand corner of the bitmap diagram also shows the MIDI Clock transmission speed in
bpm (Bits Per Minute).