Oce Arizona T220 User Manual - page 54
Océ | Operating the Arizona T220
5-44
3010100686-A
5.3.2
Print Job Settings
The following three settings may be altered if the operator chooses to change them when
the print information for a particular job is displayed.
Media Thickness
ODGS recommends that the operator measure the media thickness with a set of
calipers.This ensures optimum conditions for achieving the best possible print quality by
placing the print nozzles at the optimal height above the media.
If you pressed + or - to change setings while the print job information was displayed, the
following screen appears.
Use the
ACCEPT
key to move through the displayed digits. The selected digit has an
underline indicating it can be increased or decreased using the + or - keys. When the digit
you want is displayed, press
ACCEPT
and the underline moves to the next digit. When
you are at the last digit, pressing
ACCEPT
advances to the heat setting menu display.
Heater Duty Cycle
The purpose of the heater duty cycle is to ensure adequate drying of the ink in order to
avoid undesired printing artifacts such as bleeding, pooling, fisheyes, etc. Drying is
affected by multiple factors including the media used, image density, ink temperature,
air temperature, and 0ther environmental factors. Consequently, it is not possible to offer
a set formula that covers all printing scenarios. Therefore, it is the responsibility of the
Caution:
Do not rely on media thickness specifications listed on the
media supply box. When media thickness changes, the Pre-Fire Strip
catcher must be manually adjusted to the correct height.
Print Mode
speed 1x
Enter new media thickness:
04.00mm