Oce Arizona T220 User Manual - Foam Pads
Océ | Printer Maintenance
6-64
3010100686-A
4.
Apply solvent to a lint-free cloth and begin cleaning the capping station. Wipe
away the ink buildup on the face of the capping station and inside the ink purge
drains.
5.
Inspect drain holes. Clear clogs if necessary.
Close the gantry doors and use the Park Carriage command from the control panel to
automatically move the carriage back to the capping station.
Foam Pads
Items Required:
•
Foam Pads (7500-4173)
•
CGS-80 Solvent (3000-0057)
•
Butyl Gloves (3010101760)
Procedure:
1.
Use the Access Carriage command from the control panel to automatically move
the carriage to the blotting station (see Figure 14 on page 27).
2.
Open the gantry doors to access the capping station.
3.
Use protective butyl gloves in case of contact with ink or solvent.
4.
Inspect the foam capping pads and replace any that appear to be worn. Also check
that the pads are positioned squarely in their slots.
5.
Saturate any new pads with solvent until they expand fully.
6.
Close the gantry doors and use the Park Carriage command from the control panel
to automatically move the carriage back to the capping station.
Warning:
Don't reuse the ink soaked lint-free cloth on any other surfaces of
the printer.
Warning:
Make sure that no foreign debris is allowed to fall into the Waste Ink
Tray as this could block the drain and cause it to overflow.