Octava HDMX44-V1.3 Installation Manual - page 7
Changing EDID mode:
It is recommended to keep the EDID in the factory default MODE1. If
necessary, you may set to different EDID mode by following these
instructions.
LED Indication:
The Output LED indicates the OUTPUT that is selected (high priority).
For example, if the OUTPUT B LED is ON, then pressing channel
buttons will switch the inputs to OUTPUT B.
Step Action
Notes
1
Set the Smart Scan switch
to OFF
2
Disconnect all sources
and display from Matrix
3
Set the Progam/Lock
switch #4 to “program
mode” ( down)
4
Set the EDID to the mode
desired.(MODE 2 shown.)
See page 12 for
other EDID
modes
5
Reset Power to the Matrix
by disconnecting the
power and reconnecting
power.
.
6
The LED will now indicate
the EDID Mode that you
will program.(mode 2
shown)
LED “2” will
flash.
Input 2 is switched
to Display B
Indicates the Output that the Input will be
switched to. In this case HDMI Out B
6
13