Odyssey LI-COR Operator's Manual - Power Button
CHAPTER 2
16
Odyssey Overview and General Description
Note:
After powering off the system, the Odyssey
®
Imager may take up to 30 minutes
to reboot when power is restored.
Power Button
Briefly press the
Power
button on the front panel keypad to shut
down the Odyssey Imager. You will be asked to confirm that you
want to shut down. Press the
Y (start)
button to shut down.
Shutdown via the Browser Interface
The Odyssey instrument can also be shutdown using the browser
interface as described in Chapter 8. An account with
Administrator
access is required to use the Shutdown function.
Note:
Do not attempt to turn off the instrument by unplugging the power cable, or by
pushing ‘
O
’ on the rear power switch (if applicable).
In the event that the front-panel keypad is unresponsive and you
cannot connect to the instrument using an Internet browser, the
instrument can be reset by holding down the
Power
key for at least 4
seconds until the instrument turns off. This procedure cuts power to
the instrument and internal hard disk, so it should only be used when
communication cannot be established by any other means. The
Odyssey instrument should resume normal operation after the
Power
key is pressed again to turn the instrument back on,
though start up
may take several minutes or up to 30 minutes.