Oki B 4350N User Manual

© 2004 Oki Data Americas, Inc.

58366302

Install the Tray

1. Unpack the tray and remove the 

shipping materials.

2. Turn off the printer and unplug the 

power cord.

3. Remove the interface cable.

4. Note the location of the pins (

1), 

connector (

2) and tray opening (3).

5. Pull down the printer’s manual feed 

tray.

6. Lower the printer onto the auxiliary 

tray, aligning the holes/plug on the 

bottom of the printer on the pins/

connector on the tray. You should 

feel the printer seating and locking 

in place.

7. Attach the connection cable.

8. Reattach the interface cable.

9. Plug in the power cord and turn on 

the printer.

10.Verify installation

Models with Operator Panel:

a. Press the Menu button one or 

more times until 

INFO. MENU

appears on the display.

b. Press 

SELECT

 twice.

The MenuMap prints.

Models with Control Button:

a. Press the Control Button to take 

the printer off-line.

b. Press and hold down the control 

button for at least 2 seconds, but 

less than 5 seconds. The 

MenuMap prints.

11. Look for TRAY2 on the first page 

of the MenuMap under the 

MEDIA MENU listing. If it isn’t 

there, check to be sure that the 

connection between the printer 

and Tray 2 is secure, then reprint 

and recheck the MenuMap. 

12. Check the MEDIA MENU 

settings shown on the MenuMap 

and make any needed changes for

• TRAY2 PAPERSIZE

• TRAY2 MEDIATYPE

• TRAY2 MEDIAWEIGHT

to match the print media you will 

normally use in Tray 2. (If you need 

help with this, see “Operator 

Panels” in your on-line User’s 

Guide.

Load Paper

1. Pull out the tray.

2. Position the paper guides in the 

tray.

2

nd

 Paper Tray

Oki PN-40834406 - 500 Sheet Second Paper Tray

Installation Instructions

(continued on back)