Oki GL408e Manual - page 5
Manual is about: GL408e/GL412e WLAN Card Install Guide
of
8
5
Simple-Dispenser Installation Guide
GL4xxe Simple-Dispenser Installation
The Simple Dispenser comes with its own front cover to replace the factory-installed
front cover of the GL4xxe series printer. Follow the procedures below to install the
Simple Dispenser.
1. Make sure the printer is OFF and disconnected from the power supply.
2. Lift up the side cover to access the original housing cover (1).
3. Remove the original housing cover by unscrewing the thumbscrew (2) at the
side of the printer.
Figure 1. Removing the existing front cover and preparing to install the replacement cover.
1
4
2