Oki ML6300FB-SC User Manual - page 25
Operating instructions > 25
B
UTTON
SWITCHES
SWITCH
STATUS
FUNCTION
SEL
On-line
Sets the printer to off-line.
Off-line
Sets the printer to on-line and disalarms the
printer.
SHIFT
Used only in conjunction with one of the following
buttons: SEL, LF, FF/LOAD, PARK, TEAR described
below.
LF
On-line
Feeds paper by one line. Holding the button down
results in continuous line feeding.
Off-line
Feeds paper by one line. Holding the button down
results in continuous line feeding.
FF/LOAD
On-line and off-line
Continuous Forms
mode
Continuous form fed until first line of next page.
On-line and off-line
Cut sheet manual
mode
Ejects the cut sheet.
TEAR
On-line
Continuous Forms
mode
Delivers the continuous form to the cut position. If
the button is pressed again or data is received, the
original form position is restored.
On-line
Cut sheet manual
mode
Ineffective.
Off-line
Ineffective.
PARK
Continuous Forms
mode
If the continuous form is in position, press to
retract the form to the Pin Tractors.
(If the sprocket holes of the last page of the form
disengage from the sprocket pins, do not attempt
to eject the paper as a paper jam may result.)
SHIFT+SEL
Enters menu mode.
SHIFT+LF
Microfeed (0.14 mm step) down
Hold this button combination down for continuous
feeding or ejecting of paper.
SHIFT+FF/LOAD
Microfeed (0.14 mm step) up
Hold this button combination down for continuous
feeding or ejecting of paper.
SHIFT+PARK
On-line
Ineffective.
Off-line
Saves the set paper start position (first line print
position).
SHIFT+TEAR
On-line
Quieter print mode
Each press of the button pair progresses the printer
through Quieter print mode > High multipart print
mode > Normal print mode.
Off-line
Ineffective.