Oki ML6300FB-SC User Manual - page 29
Operating instructions > 29
Auto CR
*IBM PPR only
Select whether to perform
auto CR operation upon
receiving a carriage return
command.
Yes
No
SI Select Pitch (10CPI) *IBM
PPR/AGM only
Set how to handle an SI
command received in 10 CPI
mode.
15 CPI
17.1 CPI
SI Select Pitch (12CPI) *IBM
PPR/AGM only
Set how to handle an SI
command received in 12 CPI
mode.
12 CPI
20 CPI
Reset Inhibit
Set whether to enable or
disable an initial command.
No
Yes
Select Language Set
*EPSON only
Set whether to enable or
disable a combination of the
code page setting and the
language setting by menu.
Combined
Code Page Only
Impact Mode
Select print mode on power
on. (This item is referred to
on initialisation only by I-
PRIME or power on but not by
an initialisation command.)
Normal
Quiet
Hi Copy
Print Direction Command
Select the validity of a one-
way print setup command.
Valid
Invalid
Power Saving
Set whether to enable or
disable power save mode.
Enable
Disable
Power Save Time
Set idle time to enter power
save mode.
5 min, 10 min, 15 min, 30
min, 60 min
PE Detection
Select whether to detect
paper end or not.
OFF
ON
Table Print
Set whether to divide a path
or not to print on occasions
when printing by the same
headpin continues for 3 in or
more in the same print block.
Standard
Special
Line Spacing
Select line feed pitch.
6 LPI
8 LPI
Page Width
Set width of a line to
determine the number of ANK
(10CPI) characters to be
printed. With this setting, the
right margin is set. For
reduced-size prints, at 75%
or 50%, 136 characters are
printed.
10.6 in
8 in
Form Tear-Off
Select manual or auto as the
method to advance a
continuous form to the form
tear-off position.
Off
500 ms
1 sec
2 sec
Skip Over Perforation
Select whether to skip over
perforation or not. (When a
skip over perforation setup
command is received, the
received command is given
priority.)
Yes
No
ITEM
FUNCTION
SETTING