Oki ML6300FB-SC User Manual - page 39
Troubleshooting > 39
Too high or too low TOF
(where printing starts).
The TOF is not correctly
selected.
Initialise the printer.
Select correct TOF for cut
sheet and continuous
forms.
Select the first-line print
position and adjust the
paper top position.
Reselect the margin
correctly in the application.
Too large or small left and/
or right margins.
The left or right margin is
not correctly selected.
Incorrect positions of the
Paper Guide or Pin
Tractors. Select and adjust
the position again
depending on the paper
type.
Reselect the left and right
margins correctly in the
application.
When continuous forms are
used, the content of a
single form is printed on
two forms.
The paper length selected
in the application does not
match the physical paper
length.
Match the paper length
selected in the application
with the physical paper
length in use.
When cut sheets are used,
the content of a single
sheet is printed on two
sheets.
The paper setting selected
in the application does not
match the physical paper
size.
Match the paper setting
selected in the application
with the physical paper in
use.
It does not match the lines
per page as the printer
automatically detected.
Leave enough top and
bottom margin in the
application.
Correct the cut sheet LF
adjustment.
The content of a single line
is printed in two lines.
The left and/or right
margins are not correctly
selected.
Reselect the left and right
margins correctly in the
application.
When continuous forms are
used, several blank lines
appear in the printout.
Tear-off perforation
spacing is selected.
Cancel tear-off perforation
spacing.
Broken and uneven vertical
lines.
This may happen in bi
-
directional printing.
Use Print Registration in
the adjustment mode to
adjust.
Too large or small line
spacing.
Line spacing is not selected
correctly.
Reselect line spacing
correctly in the application.
Split print
Blanks appear in graphic
printout.
This is a paper feed error,
which is especially notable
in printing regular
characters.
This is not a failure.
Blanks or deformed
characters appear in
double height type or other
extended types.
This is a paper feed error
due to line feeding in
printing a single character.
This is not a failure.
Use the printer's built-in
fonts when you print
important documents or
bills.
PROBLEM
CAUSE
ACTION