Oki ML6300FB-SC User Manual - page 31
Operating instructions > 31
I/F Bi-Direction
Set whether to return a
device ID or not in
accordance with IEEE1284.
Enable
Disable
Parity
(Displayed only when
connected to a Serial
Interface)
None: Absence of parity bit
Odd: Odd parity
Even: Even parity
None
Odd
Even
Serial bits
(Displayed only when
connected to a Serial
Interface)
Select the data bit length.
7 bits
8 bits
Protocol
(Displayed only when
connected to a Serial
Interface)
Select an I/F Busy control
method.
Ready/Busy: Busy control by
a DTR signal
X-ON/X-OFF: Busy control by
a DC3/DC1 code
Ready/Busy
X-ON/X-OFF
Diagnostic Test
(Displayed only when
connected to a Serial
Interface)
Select to perform input/
output diagnosis of RS-232C
interface signals.
No
Yes
Busy Line
(Displayed only when
connected to a Serial
Interface)
Set a Busy Line setting of a
serial interface.
SSD-
SSD+
DTR
RTS
Baud Rate
(Displayed only when
connected to a Serial
Interface)
Select to set the baud rate.
300BPS
600BPS
1200BPS
2400BPS
4800BPS
9600BPS
19200BPS
DSR Signal
(Displayed only when
connected to a Serial
Interface)
Select the validity of the
received data.
Valid: Checks the status of a
DSR signal, and the data
received when the DSR signal
is in the SPACE state and is
determined to be valid. If the
data is received when the
DSR signal is in MARK state,
the data is determined to be
invalid and discarded.
Invalid: Regardless of the
status of a DSR signal, all the
received data is determined
to be valid.
Valid
Invalid
DTR Signal
(Displayed only when
connected to a Serial
Interface)
Set a method to switch a DTR
signal of serial interface.
Ready on Power UP
Ready on Select
Busy Time
(Displayed only when
connected to a Serial
Interface)
Set the minimum time
between BUSY to READY.
0.2 sec
1 sec
ITEM
FUNCTION
SETTING