Packet8 Virtual Office 6757i CT User Manual - Ne Keys and
Model 6757i CT Series IP Phone User Guide— 71
Li
ne Keys and
Softkeys
None Key
You can set a key to force a blank entry on the IP phone display for a specific key.
You do this by setting the key to none. The keys are added in order (from key 1 to
key 20) after any hard-coded keys have been added. If a particular key is not
defined, it is ignored. For more information about key behavior, see
"Key Display
Behavior"
on
page 52
.
Setting a None Key
Use the following procedure to configure a None key on the 6757i CT IP Phone.
1. Click on Operation->Softkeys and XML.
or
Click on Operation->Expansion Module
2. Click on the Bottom tab or the Top tab.
3. Select from "Key 1" through "Key 20" on the bottom tab or select from "Key
1" through "Key 10" on the top tab.
4. In the Type field, select None.
5. If configuring a softkey on the Bottom Keys, in the state fields, check (enable)
or uncheck (disable) the states you want to apply to this softkey.
6. Click
to save your changes.
Packet8 Web Phone UI