1. DL manuals
  2. PAG
  3. Camera Accessories
  4. Paglight C6
  5. Instruction Manual

PAG Paglight C6 Instruction Manual

Manual is about: Professional 6V Lighting Kit

Summary of Paglight C6

  • Page 1

    Professional 6v lighting kit paglight c6 instruction manual u5098 iss a jan 08.

  • Page 2

    Your paglight c6 lighting kit should contain the following components: * paglight c6 and plug-in lamp holder (assembled). * accessory ring, daylight filter, diffuser and barn doors (assembled). * 20w lamp. * camera shoe plate. * pag c6 power pack and shoulder strap. * pag power charger and primary p...

  • Page 3: Paglight C6

    Instruction manual contents section page 1 introduction 2 2 paglight c6 8 3 c6 power pack 14 4 c6 power charger 15 5 service & warranty 17 paglight c6 professional 6v lighting kit 1.

  • Page 4: Section 1

    Pag stands for broadcast quality pag ltd. Is a british company, that has been designing and manufacturing high quality equipment for the film and television industries for 40 years. In that time many pag products have broken technical boundaries and set new standards, worldwide. The limited choice o...

  • Page 5

    Professional accessories the accessory holding ring fits onto the front of the paglight c6. It accommodates a range of accessories: a frosted diffuser, a dichroic filter and barndoors. The accessory ring can be rotated and secured in the desired position. Diffuser when filming in subdued light condi...

  • Page 6

    To soften the harsh shadows caused by a bright light source, such as direct sunlight. The spot-and-flood facility helps give you further control over light intensity. Dichroic filter when supplementing daylight with your paglight c6, the colour temperature must be corrected to match daylight. You ca...

  • Page 7

    Perfect positioning the support base of the lamp head is a multi-directional mounting which allows the light to be adjusted vertically and horizontally. The pivot points are friction-adjustable to maintain the desired position in all situations of use. Mounting the paglight c6 kit is supplied with a...

  • Page 8

    Accessory/extender arm (model 1020) this short extender arm can be fitted to the accessory shoe of the camcorder. It incorporates two accessory shoes that allow both the paglight c6 and a microphone to be mounted to the camcorder. Accessory mounting bracket (model 1021) for camcorders without an acc...

  • Page 9

    Paglight c6 parts: fig. 3 7.

  • Page 10: Section 2

    Safety instructions: please read these important safety and operating instructions fully before using the paglight c6. 6v input only. Do not connect to incorrect supplies. The paglight c6 has been specifically designed as a 6v unit and on no account should any attempt be made to ‘convert’ it for use...

  • Page 11

    Switch-off the paglight c6 before removing or replacing the plug-in lamp holder. Allow the lamp to cool before removing it from the lamp holder. Do not handle the lamp envelope directly. If it is touched inadvertently, clean it with a lint-free cloth moistened with methylated spirit. Specification: ...

  • Page 12

    The lamphead the lamphead incorporates a tilting facility with a friction locking mechanism. From the horizontal position, the lamp head can be angled downwards by 15 degrees, and upwards by 60 degrees. Focussing focussing is provided by a lever on each side of the lamp body, and is continuously var...

  • Page 13

    The light. Barn doors and filters are a snap-fit onto the accessory ring, and may be assembled in any permutation. To remove, pull firmly forwards from the mounting lugs. Do not twist. Fitting is the reverse of this procedure. The barndoors and filters feature screws to adjust the tension of the hin...

  • Page 14: Section 3

    Safety instructions: in the interest of safety, and the protection of our environ- ment, please read and observe the following health and safety information. General: do not put in fire or mutilate the battery. The cells may burst or release toxic material. Do not short-circuit the battery as this m...

  • Page 15

    Local regulations. Pag ltd. Offers a recycling service for expired pag batteries, which results in the materials being recovered for re-use. Batteries must be in a discharged state, and be clearly marked “for recycling”. Return batteries by prior arrangement to: pag ltd. Tel: +44 (0) 20 8543 3131 56...

  • Page 16

    Protect the battery from severe shock, vibration and intense heat. Do not immerse the battery in water or expose it to driving rain, steam or condensing humidity. If the battery should get wet, shake out any excess water and allow it to dry naturally in a warm place. Do not attempt to use it until i...

  • Page 17: Section 4

    Safety instructions: please read these instructions fully and note all warnings before using the c6 power charger. This product is not intended for any use other than the charging of pag ‘c’ series rechargeable batteries. Important: use only on ac supplies 100-240v, 50-60hz. Supply connection to the...

  • Page 18

    Operating instructions: fit the mains input plug supplied, to the charger, by pushing it fully onto the charger body. Connect the charger to a suitable ac supply (see safety instructions). Charging the battery the charging output lead is terminated with a self-locking connector which is polarised wi...

  • Page 19: Section 5

    Service: never replace with unauthorised parts. Refer all service enquiries and orders to your nearest pag dealer or directly to pag ltd. 565 kingston road, london sw20 8sa, uk. E-mail: sales@paguk.Com tel: +44 (0)20 8543 3131 fax: +44 (0)20 8540 4116 warranty: notwithstanding any provision of any a...

  • Page 20

    Eu declaration of conformity we pag ltd. London, england. Hereby declare that the products described below conform to the relevant require- ments of the appropriate eu directives. This declaration shall cease to be valid if modifications are made to the products without our approval. Product: c6 bat...