8 ps audio international, inc. 4824 sterling dr. Boulder, co 80301 usa phone: 720-406-8946 fax: 720-406-8967 www.Psaudio.Com warranty and service inside the u.S. And canada ps audio’s warranty is 3 years parts and labor, from the date of original purchase. This means that we warranty the product its...
1 table of contents 2. Warning 2. Safety instructions 2. Overview 3. Quick start guide 3. Rear panel layout 4. Front panel controls 4. Isolated ground post 4. Power plant operation 5. Multiwave ii™ waveforms 6. Servo system 6. Troubleshooting guide 7. Specifications 8. Warranty and service what’s in...
2 warning to prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the enclosure. Refer servicing to qualified personnel only. To prevent electric shock, use a 3 prong, grounded type power cable. Any change or modifications not expressly app...
My turntable or fan based equipment is not operating normally any turntable or equipment with ac synchronous fans should not be used with multiwave ii. These products must be used with 60hz sine mode. The p300 shut down, the display is blank and the fuses are not blown if airflow is inadequate or ro...
[p-4] multiwave4 multiwave4 is full combination of p-1 and p- 2. It generates a pseudorandom collection of frequencies, however instead of generating sine waves it generates the same waveform as p-1. Again, try these settings on your system to see which one has the highest perceived benefit in terms...
3 quick start guide 1. Place the p300 in a rack or on a shelf in the audio/video system. If placed on carpet it is necessary to use isolation or accessory feet to elevate it above the carpet 1 inch, as it is essential for proper ventilation. Failure to do so could compromise the power regeneration c...
Isolated ground post using an isolated ground wire can eliminate ground potential difference problems and provide a more reliableground connection. Before attaching the isolated ground wire to the grounding post on the p300 the internal ground wire must be disconnected. Place the p300 on its back so...
Accurately on the power plant's meter. For true power consumption figures consult the owners manual of the connected product. Under normal operation a green led will illuminate. A yellow led will indicate a heavy load and is not recommeded for continous operation. A red led indicates an overload or ...
