- DL manuals
- PSA Products
- Smoke Alarm
- LIFESAVER LIFPE10
- User Manual
PSA Products LIFESAVER LIFPE10 User Manual
Summary of LIFESAVER LIFPE10
Page 1
Lifpe10_v2 10 year life battery-operated photoelectric smoke alarm user manual model lifpe10
Page 2
2 contents introduction ....................................................................... 2 installation ....................................................................... 3 operation ........................................................................... 9 maintenance and cleaning .....
Page 3
3 specification power: dc3v(cr123a) lithium battery (not replaceable) operating current: alarm volume: >85db(a) at 3 meters. Alarm sensitivity: 0.09-0.17db/m silence time: approx. 10 minutes smoke alarm device sound pattern: iso8201 comply with australian standard: as3786:2014 installation recommend...
Page 4
4 • when mounting alarms on the ceiling locate it at least 300mm away from the side wall and 300mm away from any corner. (see diagram) • when mounting alarms on a wall, use the inside wall. The recommended position is between 300mm and 500mm off the ceiling. (see diagram) • note: the performance of ...
Page 5
5 installation • modern mobile homes have been designed and insulated to be energy efficient. Install smoke alarms as recommended (refer to recommended locations). • in older mobile homes that are not well insulated compared to present standards, extreme heat or cold can be transferred from the outs...
Page 6
6 installation • avoid dusty areas, dust particles may cause smoke alarm to false alarm or fail to alarm. Use heat alarm in this location to avoid false alarms. • avoid very humid areas or near a bathroom, moisture can cause false alarm. • avoid insect-infested areas. • do not locate alarm within 0....
Page 7
7 installation mounting caution: this unit is sealed. The cover is not removable! • remove the mounting bracket from the smoke alarm. • the smoke alarm can be mounted in two ways. Using the double-sided tape provided or mounting using the provided screws and plugs. • if using the provided double-sid...
Page 8
8.
Page 9
9 operation testing the smoke alarm is operating once it is fitted onto the mounting bracket. Pressing the test button will sound the alarm. When the smoke alarm photoelectric sensor chamber senses products of combustion, the horn will sound a loud (85 db) alarm until the sensing chamber is cleared ...
Page 10
10 operation red led- hush mode indication: the red led will flash once every 8 seconds, indicating the smoke alarm device is in the hush or silence mode. Low battery indication an intermittent “chirp” with red led flashes once every 40 seconds: indicates that the smoke alarm device is low battery, ...
Page 11
11 operation the smoke alarm hush mode will automatically reset after approximately 10 minutes. If after this period particles of combustion are still present, the alarm will sound again. The hush mode can be used repeatedly until the air has been cleared. Smoke alarm removal to remove the alarm fro...
Page 12
12 maintenance and cleaning the battery is sealed inside the smoke alarm and is not replaceable. Please replace another new alarm if the low battery chirp occurs. Important: do not attempt to remove the cover to clean inside. This will void warranty. Note: smoke alarm have a service life of 10 years...
Page 13
13 trouble shooting guide problem method smoke alarm device does not sound when tested. 1. Fit the alarm on the bracket and turn the alarm body clockwise, until its fixed. 2. Clean smoke alarm device. Please refer to the “maintenance and cleaning” section. 3. If there are still failures during warra...
Page 14
14 fire safety warning: please read carefully and thoroughly. • life safety from fire in residential occupancies is based primarily on early notification to occupants of the need to escape, followed by the appropriate egress actions by those occupants. Fire warning systems for dwelling units are cap...
Page 15
15 fire safety • if the alarm is located outside the bedroom or on a different floor, it may not wake up a sound sleeper. • the use of alcohol or drugs may also impair one’s ability to hear the smoke alarm. For maximum protection, a smoke alarm should be installed in each sleeping area on every leve...
Page 16
16 product registration register this product for warranty to ensure fast and effective service. Please visit our website www.Psaproducts.Com.Au/registration to register. Please retain this warranty section and complete the details below. When you claim warranty for the product. Please present this ...
Page 17
17 warranty • psa products pty ltd (abn: 99 076 468 703) of 17 millicent street, burwood 3125 victoria, australia warrants this product for a period of five (5) years from the date of purchase, as reflected on the authorised reseller's or distributor’s invoice / receipt provided to you. Psa products...
Page 18
18 goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. What constitutes a major failure is set out in the australian consumer law. • to make a claim under warranty, take the product (with a proof of purchase) to the store where...