PSA Products LIFESAVER LIFPE10 User Manual - page 7
7
Installation
Mounting
CAUTION: This unit is sealed. The cover is not removable!
• Remove the mounting bracket from the smoke alarm.
• The smoke alarm can be mounted in two ways. Using the
double-sided tape provided or mounting using the
provided screws and plugs.
• If using the provided double-sided tape, simply peel the
adhesive paper and apply on the ceiling side of the
mounting bracket.
• Press the mounting bracket firmly against the ceiling or
wall.
• Fit the smoke alarm onto the bracket by turning the
smoke alarm clockwise on the bracket.
• If installing the smoke alarm using the provided screws
and plugs, mark the installation holes of the bracket. See
the installation diagram.
• Drill 2 installation holes approximately 5mm in diameter at
the marked position.
• Insert the two plastic plugs into the holes.
• Attach the bracket to the plastic plugs and fit the screws
tightly into the plastic plugs.
• Fit the smoke alarm onto the bracket by turning the
smoke alarm clockwise on the bracket.
• Press the button to test the smoke alarm. The alarm
sounds 3 beeps – 1.5 seconds pause, repeat it until the
button is released. If there is no sound, it indicates a
defective alarm, you can refer to the “Trouble shooting
Guide”.