PSA Products LIFESAVER LIFPE10 User Manual - page 11
11
Operation
The smoke alarm hush mode will automatically reset
after approximately 10 minutes. If after this period
particles of combustion are still present, the alarm will
sound again.
The Hush mode can be used repeatedly until the air has
been cleared.
Smoke Alarm Removal
To remove the alarm from the mounting bracket,
rotate the alarm anti-clockwise. Once the smoke
alarm is removed from the bracket the smoke alarm is
inoperative. The battery is deactivated.
WARNING: REMOVING THE SMOKE ALARM FROM
THE BRACKET WILL RENDER THE UNIT
INOPERATIVE.
Maintenance and Cleaning
In addition to weekly testing, the alarm requires periodic
cleaning to remove dust, dirt, and debris. Clean the
alarm at least once a month.
Use a vacuum cleaner with the soft brush, vacuum all
sides and cover of smoke alarm.
This alarm has a low battery monitor which will cause the
alarm to “chirp” approx every 40 seconds and the red
LED flash once at the same time for a minimum of thirty
days when the battery gets low.
If there is a defective battery or other failures, you can
refer to “Trouble shooting” for a solution, if there are still
failures during warranty, you can return to your reseller.