Qcom LR802UKN3 User Manual - Test Report
Unless otherwise stated the results shown in this test report refer only to the sample(s) tested. This test report cannot be reproduced, except in full, without prior written permission of
the Company. 除非另有說明,此報告結果僅對測試之樣品負責。本報告未經本公司書面許可,不可部份複製。
This Test Report is issued by the Company under its General Conditions of Service printed overleaf or available on request and accessible at
http://www.sgs.com/terms_and_conditions.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this Test Report is
advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole
responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. Any
unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law.
No. 33 Wu Chyuan Road, Wuku Industrial Zone, Taipei County, Taiwan / 台北縣五股工業區五權路 33 號
t (886-2) 2299-3939
f (886-2) 2299 -3237
www.tw.sgs.com
SGS Taiwan Ltd.
台灣檢驗科技股份有限公司
Member of the SGS Group
No.1
No.2
perfluorohexane (CAS No.:
000355-42-0)
mg/kg
With reference to US EPA 5021 method.
Analysis was performed by GC/MS.
1
n.d.
---
Result
Test Report
No. : CE/2008/67049A
Date : 2008/07/07
Page : 11 of 20
566-1, KAO-SHI ROAD, YANG-MEI, TAO YUAN, 32642 TAIWAN, R. O. C.
WALSIN TECHNOLOGY CORPORATION
*CE/2008/67049A*
Test Item (s):
Unit
Method
MDL
4. " - " = Not Regulated
10. Beryllium oxide (BeO): Calculate from Beryllium content multiply 2.7753 factor.
11. Since beryllium copper is a metal alloy of copper and beryllium and the test result is n.d.
for beryllium, we can have conclusion that the beryllium copper is n.d..
12. Antimony trioxide(Sb
2
O
3
): Calculate from antimony content multiply 1.197 factor.
5. "---" = Not Conducted
6. ** = Qualitative analysis (No Unit)
7. Negative = Undetectable / Positive = Detectable
8. Negative = "< 1.0 %", Positive = "> 1.0 %"
9. The MDL is 5ppm for the single compound of CP
2. n.d. = Not Detected
3. MDL = Method Detection Limit
Note: 1. mg/kg = ppm