Qcom LR802UKN3 User Manual - Test Report
備註(Note):
測試部位描述 (TEST PART DESCRIPTION):
1. mg/kg = ppm
4. 根據2005年10月13日歐盟會議公佈2005/717/EC,修訂2002/95/EC內容,通過解除高分子材質
3. MDL = Method Detection Limit (方法偵測極限值)
2. n.d. = Not Detected (未檢出)
6. "-" = Not Regulated (無規格值)
測試報告
Test Report
ACES ELECTRONIC CO., LTD.
桃園縣中壢市東園路13號
NO. 13, DONGYUAN RD., JHONGLI CITY, TAOYUAN COUNTY 320, TAIWAN, R.O.C.
宏致電子股份有限公司
7. 樣品的測試是基於申請人要求混合測試,報告中的混合測試結果不代表其中個別單一材質的含量.
(The samples was/were analyzed on behalf of the applicant as mixing sample in one testing.
The above results was/were only given as the informality value).
*CE/2008/34807C*
Boiling-water-extraction:
Negative = Absence of Cr(VI) coating / surface layer(鍍層中偵測不到六價鉻),
Positive = Presence of Cr(VI) coating / surface layer(鍍層中偵測到六價鉻);
the detected concentration in boiling-water-extraction solution is equal or
greater than 0.02 mg/kg with 50 cm
2
sample surface area.
該溶液濃度≧0.02 mg/kg with 50 cm
2
(sample surface area)
中十溴聯苯醚之使用限制. (According to 2005/717/EC DecaBDE is exempt.)
NO.1
:
銀色金屬腳 (含鍍層) (不含料帶) (SILVER COLORED METAL PIN (INCLUDING THE PLATING LAYER)
(EXCLUDING THE FRAME))
5. Spot-test:
Negative = Absence of Cr(VI) coating / surface layer(鍍層中偵測不到六價鉻),
Positive = Presence of Cr(VI) coating / surface layer(鍍層中偵測到六價鉻);
The tested sample should be further verified by boiling-water-extraction method if the
spot test result cannot be confirmed.
(當該測項無法確認時, 測試樣品可藉由boiling-water-extraction測試方法進一步確認)
號碼(No.): CE/2008/34807C
日期(Date): 2008/03/31
頁數(Page): 3 of 6
The content of this PDF file is in accordance with the original issued reports for reference only. This Test Report cannot be reproduced, except in full,
without prior written permission of the Company
SGS TAIWAN LIMITED
NO. 136-1, Wu Kung Road, WuKu Industrial Zone, Taipei county, Taiwan.
t(886-2) 22993939 f(886-2) 2299-3237 www.sgs.com.tw
. Any unauthorized alteration, forgery or falsification of the content or appearance of this report is unlawful and
offenders may be prosecuted to the fullest extent of the law.
The content of this PDF file is in accordance with the original issued reports for reference only. This Test Report cannot be reproduced, except in full,
without prior written permission of the Company
SGS TAIWAN LIMITED
NO. 136-1, Wu Kung Road, WuKu Industrial Zone, Taipei county, Taiwan.
t(886-2) 22993939 f(886-2) 2299-3237 www.sgs.com.tw
. Any unauthorized alteration, forgery or falsification of the content or appearance of this report is unlawful and
offenders may be prosecuted to the fullest extent of the law.