Quality Craft M870P-28ADC Instruction Manual - page 11
of
12
11
fig. B
2. Drill the holes with diameter 3/4 inches
(10 mm) and depth 3/4 inches (10 mm) on
the mantel. Each PLASTIC CONNECTOR
needs 3 holes. See Fig. C.
fig. C
fig. D
3. Gently install the KD NUTS into the
drilled-holes with hammer as shown in
Fig. D.
4. Attach the PLASTIC CONNECTOR and
lock in place with KD SCREWS as shown
in Fig. E.
fig. E
OPTION 2:
Use the SMALL L-BRACKETS and
SCREWS.
1. Place the SMALL L-BRACKET to the
unit as shown and mark the drill-holes on
the mantel as shown in Fig. F.
fig. F
2. Drill the holes with diameter 1/16
inches (2 mm) and depth 5/16 inches
(8 mm) on the mantel. Each SMALL L-
BRACKET needs 4 holes. See Fig. G.
R E P A I R S E T