Quality Craft M870P-28ADC Instruction Manual - page 7
7
Step 5: Attach the FRONT UPPER PANEL
(C ) to the LEFT AND RIGHT FRONT UPPER
PANEL (D and E) with 2 KD SCREWS (1
screw on each side). See Fig. E.
fig. E
Step 6: Attach 2 PLASTIC CONNECTORS on
the upper side of FRONT UPPER PANEL (C)
with 4 KD SCREWS (2 at each plastic con-
nector). See Fig F.
fig. F
Step 7: Install the TOP PANEL (A) to the unit
as shown and attach with 4 KD SCREWS.
See Fig G.
Step 8: Attach 2 MOUNTING FEET to
fireplace insert (one on each side) with 8
MOUNTING FEET SCREWS (R) (4 screws in
each mounting foot). See Fig. H.
fig. H
Step 9: Carefully place the INSERT in the
unit opening. The front of INSERT should be
flush with the front of the mantel. Care-
fully lift the INSERT into the mantel until the
top stopper is against to mantel. Attach 2
MOUNTING CLIPS (U) to the top side of the
insert with 2 SHORT KD SCREWS (T). Attach
2 MOUNTING BRACKETS (V) to the MOUNT-
NING FEET (R) and attach to the BASE with 2
KD SCREWS (W). See Fig. I.
A S S E M B LY I N S T R U C T I O N S