Quality Craft M870P-28ADC Instruction Manual - page 9
9
M A I N T E N A N C E
ON/OFF: Press this button for main power
and flame effect. The indicator light will turn
on. See below for other control switches.
750W: For low heat function - Press this
switch while the ON/OFF switch is in the on
position for low heat. The indicator light will
turn on.
1500W: For high heat function - Press this
switch while the ON/OFF switch and the
750W switch are in the on position for high
heat. The indicator light will turn on.
TEMPERATURE CONTROL: To adjust the tem-
perature to your individual requirements,
turn the temperature control dial to the right
(clockwise) to increase the desired tempera-
ture and to the left for lower temperature.
This temperature control dial can only be
used while the ON/OFF switch and 750W &
1500W switches are in the ON position.
DIMMER CONTROL KNOB: Turn the dimmer
dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer
switch can only be used when the ON/OFF
switch is in the on position.
NOTE: When the ON/OFF switch is turned
off, all other heater functions will stop even
though the switches may be in the
on position.
MAINTENANCE
WARNING
Disconnect power and unplug the power
cord before attempting any maintenance or
cleaning to reduce the risk of fire, electric
shock or damage to persons. The bulbs in
your unit can become extremely hot. Allow
at least 10 minutes between turning off the
unit and removing the light bulbs to avoid
the accidental burning of the skin.
RISK OF FIRE:
DO NOT EXCEED THE
RECOMMENDED BULB
WATTAGE.