Quality Craft M870P-28ADC Instruction Manual - page 5
5
A S S E M B LY I N S T R U C T I O N S
PARTS LIST:
Fireplace insert
1
A) Top panel
1
B) Base panel
1
C) Front upper panel
1
D) Left front upper panel
1
E) Right front upper panel
1
F) Left front lower panel
1
G) Right front lower panel
1
H) Left upper side panel
1
J) Right upper side panel
1
K) Left lower side panel
1
L) Right lower side panel
1
M) Front lower panel
1
P) 3-holes wood connectors
2
Q) 4-holes wood connectors
2
R) Mounting feet
2
S) Mounting feet screws
8
T) Short KD screws
2
U) Mounting clips
2
V) Mounting brackets
2
W) KD screws
56
X) Plastic Connectors
12
Y) SELF REPAIR SET
Touch-up repair paint (bottle)
L-shape bracket
2
Screws for L bracket
8
Plastic connectors
1
KD screws
3
KD nuts
3
Z) WALL ANCHOR SAFETY CABLE
Wall anchor
1
Screw for wall anchor
1
Screw for mantle
1
Safety cable
1
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
MANTEL ASSEMBLY:
CAUTION: Place a piece of cardboard or
protective sheet on the floor in order to avoid
scratching the decorative surface of your
mantel during assembly.
Please DO NOT fully tighten the KD screws
until all panels are assembled.
NOTE: Each plastic connector is pre-assem-
bled (pre-drilled) on the specific panels with
2 screws. If the KD screw(s) do not fit during
assembly, loosen the 2 (pre-drilled) screws
to adjust the plastic connector until the KD
screws are able to be installed. Tighten all KD
screws once all panels are assembled.
Step 1: Attach 10 PLASTIC CONNECTORS [X]
to the PANELS (F, G, H, J, K and L) as shown in
Fig. A. (2 pcs KD SCREWS for each CONNEC-
TOR). Attach PANEL K and PANEL H together
with 4-HOLES WOOD CONNECTOR (Q) and 4
KD SCREWS. Attach PANEL L and PANEL J
together with 4-HOLES WOOD CONNECTOR
(Q) and 4 KD SCREWS. Attach PANEL F and