Quality Craft M870P-28ADC Instruction Manual - page 6
6
PANEL D together with 1 KD SCREW. Attach
PANEL G and PANEL E together with 1 KD
SCREW. Attach 2 x 3-HOLES WOOD CONNEC-
TORS (Q), one at each side, to PANEL C with
4 KD SCREWS (2 screws for each 3-HOLES
WOOD CONNECTOR).
fig. A
Step 2: Attach the LEFT SIDE PANEL (H and
K) to the LEFT FRONT PANEL (D and F) with
2 KD SCREWS. Attach the RIGHT SIDE PAN-
EL (J AND L) to the RIGHT FRONT PANEL (E
& G) with 2 KD SCREWS. See fig B.
fig. B
NOTE: If the KD SCREW(S) do not fit during
assembly, loosen the 2 screws to adjust the
PLASTIC CONNECTOR until the PANELS/KD
SCREWS can be installed.
Step 3: Attach the LEFT (D, F, H and K) and
RIGHT (E, G, J and L) SIDE PANELS to the
BASE PANEL (B) using 4 KD SCREWS (2
screws on each side). See Fig C.
fig. C
Step 4: Attach the FRONT LOWER PANEL
(M) to the LEFT FRONT LOWER PANEL (F)
and RIGHT FRONT LOWER PANEL (G) with
2 KD SCREWS (1 screw on each side). See
Fig D.
fig. D
A S S E M B LY I N S T R U C T I O N S