Quantum GoVault 40GB Quick Start Manual - page 4
4
Installing the Internal GoVault Dock
Quick Start Guide
If the procedures presented in this subsection do not appear to be appropriate for your
workstation or server system, stop the installation attempt and seek assistance from the
appropriate hardware manufacturer.
Procedure
0
1
As required:
a
Save and close your open files and terminate all running applications.
b
Shut down the workstation or server system.
c
Disconnect the AC power cord from the facility AC power receptacle.
2
Remove the cover from the workstation or server system.
3
Install the SATA card in an empty PCI slot and fasten the card to the computer using
one screw (see
figure 2
).
Figure 2 Installing the SATA
Card
Installing the Internal
GoVault Dock
0
After you have installed the SATA card, or if your computer workstation or server system
already has either a SATA-equipped motherboard or a SATA-compliant host bus adapter
PCI card, use the following procedure to install the internal GoVault dock.
Procedure
1
If you have just installed a SATA card, then you already have shut down the
computer and removed the cover. In this case, skip to step 4 of this procedure.
If your computer workstation or server system already had either a SATA-equipped
motherboard or a SATA-compliant host bus adapter PCI card, then proceed to step 2
of this procedure.
Note:
This procedure is only necessary if your workstation or server system does not
already have a SATA-equipped motherboard or a SATA-compliant host bus
adapter PCI card installed.
Note:
See your computer manufacturer’s instructions for the proper procedures
to remove the cover.
SATA card
PCI slot