Quantum GoVault 40GB Quick Start Manual - page 7
Installing the External GoVault Tabletop Dock
7
GoVault™ for Windows
14
Use Windows
My Computer
to verify successful GoVault installation and
configuration (see
figure 8
).
15
Perform a number of file copy operations to and from the GoVault cartridge to verify
the disk read/write functions.
16
If you are going to install both the GoVault system application software and the
backup application software, then proceed to
Installing the GoVault System
Application Software
on page 9.
If you are not going to install the GoVault system application software, then skip to
Installing the Backup Application Software
on page 10.
Figure 8 Successful
Configuration Display
Installing the External GoVault Tabletop Dock
Install the external GoVault Tabletop dock and cartridge as follows:
1
Connect the drive-end (Mini-B) connector of the USB interface cable to the Mini-B
USB port on the rear panel of the GoVault Tabletop dock (see
figure 9
).
2
Connect the DC power output plug of the power adapter/converter to the DC power
jack on the rear panel of the dock.
3
Carefully position the dock in a secure location that provides adequate circulation for
the rear panel air vents (see
figure 9
).
Note:
If you do not install the GoVault system application software, the
Windows operating system might assign the low-speed Programmed I/O
(PIO) mode for GoVault data transfer operations. Use the procedures in
appendix B of the GoVault for Windows User’s Guide to determine if this is
the case and, if necessary, configure the operating system to use the high-
speed Direct Memory Access (DMA) mode for GoVault data transfer
operations.
GoVault