Quantum GoVault 40GB Quick Start Manual - page 8
8
Installing the External GoVault Tabletop Dock
Quick Start Guide
4
Plug the power adapter/converter into a 115/230 VAC facility power receptacle and
verify that the LED on the front panel of the GoVault Tabletop dock illuminates.
Figure 9 GoVault Tabletop
Rear Panel
5
Connect the system-end (standard) connector of the USB interface cable to an
available USB port on your workstation or server system and verify that the system
launches the
Found New Hardware
wizard that finds and configures the device driver,
assigns a drive letter, and enables read/write access.
6
Use Windows
My Computer
to verify successful GoVault Tabletop configuration (see
figure 8
).
7
Insert a GoVault cartridge into the dock and verify that the front panel activity LED
indicator signifies a successful cartridge load operation (see
Inserting Cartridges
on
page 11).
8
Perform a number of file copy operations to and from the GoVault cartridge to verify
the disk read/write functions.
9
If you are going to install both the GoVault system application software and the
backup application software, then proceed to
Installing the GoVault System
Application Software
in the next subsection.
If you are not going to install the GoVault system application software, then skip to
Installing the Backup Application Software
.
Note:
If you do not install the GoVault system application software, the
Windows operating system might assign the low-speed Programmed I/O
(PIO) mode for GoVault data transfer operations. Use the procedures in
appendix B of the GoVault for Windows User’s Guide to determine if this is
the case and, if necessary, configure the operating system to use the high-
speed Direct Memory Access (DMA) mode for GoVault data transfer
operations.
Air vents
Mini-B USB port
DC power jack