Quantum GoVault 40GB Quick Start Manual - page 5
Installing the Internal GoVault Dock
5
GoVault™ for Windows
2
As required:
a
Save and close your open files and terminate all running applications.
b
Shut down the workstation or server system.
c
Disconnect the AC power cord from the facility AC power receptacle.
3
Remove the cover from the workstation or server system.
4
Select an available internal drive bay and, if required, remove the bay cover.
5
Slide the internal GoVault dock into the bay and secure it to the computer chassis
with two mounting screws on each side (see
figure 3
).
Figure 3 Installing and
Securing the GoVault Dock
6
Connect one end of the SATA data cable to the SATA data connector on the back of
the internal GoVault dock (see
figure 4
).
Figure 4 Connecting the SATA
Data Cable to the Dock
7
Carefully route the SATA data cable from the internal GoVault dock and connect the
other end to either the SATA-equipped motherboard or the SATA card (see
figure 5
).
Note:
See your computer manufacturer’s instructions for the proper procedures
to remove the cover.
Caution:
Do not force SATA connections. SATA connectors are designed to fit
one way only. If you encounter any difficulty in making the SATA
cable connection, rotate the cable and try again.
Internal GoVault dock
SATA data connector
SATA data cable