Quincy Compressor QED 1050 Instruction And Maintenance Manual - page 52
Text on figure
(1)
Main chart
(2)
Main chart signal
(3)
Chart range
(4)
Minimum
(5)
Maximum
(6)
Chart band
(7)
Low
(8)
High
(9)
Off
The screen shows the main chart signal, the actual settings of the chart range and the chart band. To modify
these settings, proceed as follows:
• Press the Enter key; the first item, chart range, becomes highlighted.
• Press the Enter key to modify the chart range or press the arrow down key to modify the chart band.
Modifying the chart range
Select the chart range as described above and proceed as follows:
• Press the enter key; the minimum setting becomes highlighted. Press the enter key to modify the minimum
setting or use the arrow down key to modify the maximum setting.
• Press the enter key to accept the modification.
Modifying the chart band
Select the chart band as described above and proceed as follows:
• Press the enter key; the low band setting becomes highlighted. Press the enter key to modify the on/off
setting or use the arrow down key to modify the low setting.
• Press the enter key to accept the modification.
• Proceed in the same way to modify the high band settings.
Instruction book
2920 1818 00
51