QuStream AAB6214 Technical Manual - page 11

I

NTEGRITY 

600

–

AES600

F

AMILY

Publication 81-9059-0632-0, Rev. A 

June 2008

Proprietary Information of QuStream

3-4 

NOTE 

Do not force the card into position.  If the card does not seat with gentle pressure, back it out, 

realign with the card guides and reinsert the card. 

6.

When the card is properly seated, press the card ejector lever toward the board to lock the card in 

position. 

7.

Once the main board is seated and locked, and all connectors have properly mated, secure the rear 

connector panel to the chassis frame by tightening the retention screw.   

8.

Close the chassis frame front access door. 

Figure 3-2  Installing Main Circuit Board 

3.3

R

EAR 

P

ANEL 

S

IGNAL 

C

ONNECTIONS

Input and output connections to the module are made through 6-pin detachable connectors on the single-

width rear connector panel.  Each connector provides 2 physical input or output connections for a total 

of 2 Input and 14 Output connections on each rear panel.  Rear connector panel layout is shown in 

Figure 3-3.  When making audio connections to the AAB6214 module, follow the pin-out data for rear 

panel audio connections presented by Figure 3-4 and Table 3-1.  Use good quality cable and ensure that 

the mating plug is properly installed.