QuStream AAB6214 Technical Manual - Chapter 4 Operation

Integrity 600 – AAB6214 Analog Audio DA 

Publication 81-9059-0631-0, Rev. A 

July 2008

Proprietary Information of

Q

U

S

TREAM

4-1 

Chapter 4 Operation 

4.1

O

PERATION

There are no operating controls located on the AAB600 modules.  Certain operating parameters of the 

DA module may be selected or modified through an external control device such as the Integrity 600 

Series Remote Control Panel RCP-503, or the SOFT603 PC based software application, if the chassis 

frame is equipped with at least one NET 603 Frame Controller module.  While most installations do 

contain the frame controller card, the AAB6214 module will function without a controller card present 

in the frame; however, options from the configuration menus discussed in this chapter can not be chosen 

or changed in the field.  The module will be factory programmed prior to shipment.  Refer to the RCP-

503 Technical Manual, QuStream Publication 81-9059-XXX-0 for control panel operation procedures.  

The following paragraphs introduce the configuration options and adjustments available through each 

configuration menu. 

4.2

M

AIN 

M

ENU 

-

S

CREEN 

1 

Figure 4-1 shows screen 1 of the main menu display for the AAB6214 DA module.  Entries on the menu 

screen and functions available through each are discussed below. 

Figure 4-1  Main Menu Screen 1 

LINKING  

Gain of each analog input signal can be adjusted by selections on the main menu screen in one of two 

ways - the audio channels may be adjusted independently (Linking Off) or the two signals may be 

linked together (Linking On).  When the signals are linked, gain for both channels is adjusted as a group 

by a single control, and the balance between the two may be adjusted.   Select the desired linking mode